Основные инструмента каменщика. The main tools of the mason

Слайд 1

Государственное профессиональное бюджетное общеобразовательное учреждение Арзамасский техникум строительства и предпринимательства Зачетная работа по английскому языку Основные инструмента каменщика Выполнил : Студент 2 курса Группа СЭЗС-17 Козлов Артём Арзамас 2018

Слайд 2

Basic Mason tools Kelma -the steel shovel polished from both parties with the wooden or plastic handle - is intended for leveling of a solution on a laying, filling with a solution of vertical seams and cutting in seams of an excess solution.

Слайд 3

Basic Mason tools Hammer- kirochka - Mason uses in the cabin of the whole brick and not half-number bricks and so their Tesco.

Слайд 4

Basic Mason tools Jointing -serves for processing of seams, smoothing and consolidation of front seams of a brickwork with simultaneous giving to them the convex, concave or flat form. Grouting masonry

Слайд 5

Basic Mason tools Building level -used to check the horizontal and vertical masonry. The displacement of the bubble to the left or right from the middle position shows that the surface on which the level is set is not horizontal, and the more its slope to the horizon, the more the bubble shifts from the middle position.

Слайд 6

Basic Mason tools Mortar shovel -serves for feeding and spreading the solution on the wall, mixing it in a box.

Слайд 7

Basic Mason tools Cord - line - twisted cord is 3mm thick, which pull in the clutch miles between lead and lighthouses as a guide to ensure straightness and horizontal rows of masonry and extracts of the same thickness of horizontal seams.

Слайд 8

Basic Mason tools The box of the Mason- is intended for reception and giving of a solution to a workplace of the Mason. In industrial construction use the design of the box provided for lifting "garland" up to five loaded boxes.

Слайд 9

Basic Mason tools Roulette or folding meter -measuring tools, which mark the axes and positions of structures, make control measurements of masonry

Слайд 10

Basic Mason tools Plumb -consists of a steel cone-shaped load, twisted cord and aluminum strip for winding the cord, is used to check the verticality of the walls, piers, poles and corners of the masonry, ie for hanging masonry.

Слайд 11

Basic Mason tools The square-two rectangular plates connected rigidly at an angle of 90 degrees. Strict perpendicularity is the main requirement to the square. On it the Mason is guided in the work, to check with him, stacking each brick. The slightest error adversely affects the result of masonry. One side of the square, as a rule, has the form of a ruler. The second is more thick, needed for a tight connection with the surface of the brick.

Слайд 12

Thanks for watching